IMR Trail Boss was designed specifically for low velocity lead bullets suitable for Cowboy Action shooting. It is primarily a pistol powder but has some application in rifles. It is based on a whole new technology that allows very high loading density,
good flow through powder measures, stability in severe temperature
variation, and, most importantly, additional safety to the handloader.
IMR® TRAIL BOSS® REDUCED LOADS
FOR RIFLE AND PISTOL
in the powder description section, Trail Boss was designed primarily for
reduced loads using lead bullets in pistol cartridges. However, Trail
Boss offers superb versatility in rifle cartridges producing reduced
loads using lead or jacketed bullets. These reduced loads make firing
such cartridges as the 300 Winchester Magnum or even the 458 Winchester
Magnum pure fun!
If you don't see Trail Boss data for your favorite cartridge we have a formula for developing loads for all cartridges and it's simple to follow. This formula may be used in both rifle and pistol applications:
where the base of the bullet to be loaded is located in the case and
make a mark on the outside of the case at this location. Then fill the
case to that mark with Trail Boss, pour into the scale pan and weigh.
This is your maximum load. Pressures will be below the maximum allowed
for this cartridge and perfectly safe to use!
Take 70% of this
powder charge weight (multiply the maximum load from step 1 by .7), and
that is your starting load. Start with this beginning load and work up
to your maximum charge, all the while searching for the most accurate
reduced load. Once found, the fun begins!